Dimensions
Dimensions (H x W x D)
1.81" x 6.54" x 4.45" (46 x 166 x 113 mm)
Weight
-
Amplifier
Amplifier Class
Class D
Channels
2
Amplifier Power
Rated Continuous (RMS) Power (Manufacturer Rating @ 4 Ohm)
100 W x 2
Rated Continuous (RMS) Power (Manufacturer Rating @ 2 Ohm)
150 W x 2/300 W x 1 (Bridged)
Amplifier Processing
Signal-to-Noise Ratio, referred to highest rated power (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio, referred to 1 W (A-weighted, 20 Hz-20 kHz noise bandwidth) Analog inputs
-
Signal-to-Noise Ratio (Manufacturer Rating)
-
Damping Factor @ 4 Ω
-
Damping Factor @ 2 Ω
-
THD+N @ rated power
< 1%
Frequency Response (+0, -1dB)
10 Hz-45 kHz
Input Voltage Range @ RCA Inputs
-
Input Impedance
-
Remote Level Control
-
Remote Level Modes
-
Channel Input Mode Switch
-
Pass-through Preamp Output
-
Source Channel Selection for PreOuts
-
Amplifier Filters
Bass Boost EQ
0 to +12 dB @ 85 Hz
Output Polarity Switch
-
Filter Mode(s) Channels 1 & 2
High-Pass or Low-Pass
Filter Slope(s) Channels 1 & 2
-
Filter Frequency Range Channels 1 & 2
40 Hz-400 Hz
High-Pass/Low-Pass Full Range Filter
-
HP Variable Crossover Frequency Range
-
LP Variable Crossover Frequency Range
-
Infrasonic Filter
-
Detented, Calibrated Filter Potentiometers
-
Electrical
Operating Voltage
-
Current Consumption (idle)
-
Current Consumption (standby)
-
Fuse Rating
-
Recommended Fuse Type(s)
-
Minimum Copper Power/Ground Wire Gauge
-
General
Water/Dust Protection Rating
IP65
Operating Temperature Range
-
Protection Circuits
Overload
Warranty/Certifications
Certifications
-
Warranty
2 Years